Gentlemen, I have output and firmly believe the TS-890 itself is the issue. It appears that turning the data mode on using the Data Button on the rig does not select the USB Audio as the data source.

Well, I just had QSO with Buz, and he gave good report, so think have it figured out for now. Afraid to turn rig off, hi hi. What a great club this is with so many trying to help me solve this issue.

Saw you John. Finally putting signal in air, but noise level here is high. Calling CQ at abt +1300 now does anyone see me? Jim K5SP Sent from AT&T Yahoo Mail on Android

Photo of rig settings. Test CAT button fails also. Rig is on COM5, BAUD 38400 Sent from AT&T Yahoo Mail on Android

I have the article in hand. Am decoding FT8 signals. When I try to xmit, I get a rig control error. Screen shot attached. Sent from AT&T Yahoo Mail on Android

Sitting in radiology waiting room at VA HOSPITAL. That's a good point but the microphone is not connected. Jim K5SP Sent from AT&T Yahoo Mail on Android

I did forget to mention that I have a laptop that I used upon which I installed MixW and digipan. The result was the same. So, based upon all this, it seems to be narrowed down to the USB cable, or we

Okay, I have tried: MixW3.2.105 Digipan PskExpress Fldigi (can't get it work at all, probably operator error). All with same results. So frustrated. Quitting for the night, and have to be at VA hospit

Tried Digipan and same problem. Am not home right now. Will call you if I can. Sent from AT&T Yahoo Mail on Android

Is there anyone out there that is using a TS-890 with MixW software that might have a solution for my problem. I have set up the rig according to the manual, and have set the Data input to be from the

And I am dead in the water Sent from AT&T Yahoo Mail on Android

Everything looks good on that. When I change to speakers, mixw is warbling like it should . When I switch back to the codec get signals in waterfall. When I try to transmit, it keys the rig, but no mo

I have a new TS-890, and wish to continue to use MixW for my software application. I have been through that part of the manual, have ensured that all comm ports are being set up properly to match the

That's what I use. I don't see anything on 24920 at this time. Jim K5SP Sent from AT&T Yahoo Mail on Android

As many are aware, there were some issues with the Great Pumpkin Sprint contest scoring software. It is anticipated that the software will be debugged, corrected, and available sometime later today. I

Yes, Have contacted the software guru. He has had very little time to devote to the software. He will attempt to debug the issue and correct the problem today. If possible, he will recover all the log

Well, we have to find the correct email address. The one in his application is bouncing, so, he has not received the email notifying him that his membership is approved and with his number. Jim K5SP

Please join me in welcoming new member(s): 2946 Mark N2UEM 10-09-22 Jim K5SP Executive Director

Calling CQ around 24921.100. No takers, see some FT8 above 24922.

Okay, there must be a setting somewhere that I missed. This will have to be checked out by David. Will let you know when he has it fixed. Jim K5SP