Phil, Send me an email so I can get your email address and I'll forward the article to you. You might want to post it on your QRZ page. kc3fl@... John KC3FL

Barry: Thought about taking out a chunk of the tree just below the antenna and then gluing it back together, but problem was how to hold up top of tree while sawing of a few feet. Jerry

Jerry Easiest way to lower the height is with a chainsaw. Bonus is wood for the winter. Hope to see you on the doubleheader Barry

Hi all, I just use a very simple inverted-L and it does pretty good.   It runs vertical for about 65 feet and then horizontal the rest of the length over to another tree.   I only have two 1/8th

Hi John, I too would like the article about the 40, 80 and 160 meter end fed antenna. 160 meters ought to be interesting. Phil, K8PVH

John, I'd like to get the article on the end fed. I've never worked 160 and don't have much experience with 80 either. I might be able to get some wire in the air before the next leg of the low band

160m antenna here is an Alpha-Delta DX-A which worked pretty well until I raised one end into tree and tree grew. It messed up the angle and now is non-resonant on 160m. Just need to get at tree and

Jerry, Lot's of information on 160m antenna's. What do you run on 160m? Me? I just "force feed" my 80m vertical. When the roll-back circuits kick in, I can still easily make Q's with Fred, W0PE, in

Wish that K9DX's remote site was still running. It had 9 `110 Ft. verticals in a circle (like a 4 square) with a doghouse in middle for tuning. Then there were all the Beverages. Visited there a

My beverage is short at only 150 ft and it works great on 160 and 80. I've even used it on 40 and 30 mtrs. I used something like a 470 ohm terminating resistor but I got tired of changing out the

The setup that many use is a vertical on 160m with a beverage antenna for receive. The beverage antenna doesn't have to be very high... just run it along a fence or even lower. A friend's lot borders

Please add me in too John. I had a very, very poor temp setup that I can no longer setup and take down. Sure would like to get something up for 160 that WORKS and I could leave up! Thanks! -- Rick

I would be interested in 160m antenna designs as well! -p W7PFB 73, Don’t forget to smile and have fun!

Yes...I have been wanting to put something together for 160 meters. So I would be interested in any suggestions. Thanks. 73 Lee N5SLY

Lee, I think you're right that it will depend on multipliers. I got lucky the last night when Venezuela, Panama, Puerto Rico and of all things England popped up. I had such a poor showing in the 160

The following files have been uploaded to the Files area of the main@070Club.groups.io group. /Contest Results/Results-Triple Play-2020.pdf By: stan

Lee, I live in an HOA with fairly tight rules. but I have two neighbors who do not complain to the HOA if I erect a temporary Inverted-L running running 22 or 24 gauge hookup wires thru their palm

I can't do 160 meters...no antenna. I don't use an amp. 100 watts is all I need. Much more important is a good antenna in my opinion. I think the winner will be the one who gets the most

Lee, I love it! John made a hellava push on this one. It will be tilly-bar-the-door on the Doubleheader. Will you be able to get on 160M in this critical test? Could it make the difference? John

Stan, Can't wait to see the Leader Board for the RC3 Cup. I wouldn't be surprised to see John pass me. Good for him!!! The last contest of the year will determine the winner I'm sure...but I can