Re: Proper adjustment of audio levels for transmit


 

Test Test Test

----- Original Message -----
From: David
To: 070@yahoogroups.com
Sent: Thursday, May 24, 2012 5:20 PM
Subject: [070] Re: Proper adjustment of audio levels for transmit





--- In 070@yahoogroups.com, "David" <aj4tf@...> wrote:
>
>
> I'm sure this will start a war, but I don't think this is the right way to do it. I guess everyone has their opinions.
>
> http://www.youtube.com/watch?v=I3CwHaX7t5M
>

What I meant was, I believe the method described in the video above is correct, and the method described below is not.

>
>
> --- In 070@yahoogroups.com, Ld Rockne <pops435@> wrote:
> >
> > Hello,
> > After reading all the posts on the above topic, I started to re-adjust my levels.
> > Made a couple contacts with folks who said my sig was good, but could not raise
> > VK or ZL land.
> >
> > So, after attempting all this, I decided to look at the PODXS file's to see if there was a tutorial
> > on adjusting levels. VE3OIJ posted one, and it indicated that the way I had been running my levels were correct. i.e. RF power out (on the xmitter) to 100% (100Watts).
> > I adjusted my Signalink TX level to 20 Watts, as measured on my Wattmeter. Note: My RF out is still set at 100%. My IMD Meter reads -34 db.
> >
> > I am calling CQ on 20mMeters right now, so if my sig is bad please let me know now.
> > Because I will be doing the TDW thing in a couple hrs.
> >
> > TU & 73, Larry WA7HDZ #404
> >
> >
> > ________________________________
> >
> >
> >
>

Join main@070Club.groups.io to automatically receive all group messages.